Your vehicle features a factory setup with both left and right LED bars, meaning there are two available power sources. Our kit includes two corresponding connectors, but you only need to use one (either the left or right side) to power your new LED emblem.

Installation Steps:

  • Inspect the Plugs: Locate your factory (stock) LED bar plugs on both sides.
  • Choose a Side: Decide which side (left or right) offers easier access or better wire management for your installation.
  • Connect the Emblem: Once you’ve chosen a side, connect the LED emblem to that specific plug.
  • Refer to Photos: Please check the attached photos for a detailed view of the wiring and connection points.

Note: You do not need to connect both plugs. One connection is sufficient to power the emblem.

led bar plug 021501

Please refer to the attached photo for instructions on how to connect the LED emblem to the LED bar plug.

For testing, you can follow the simple connection shown in the photo. Once you have confirmed the connection is working, you must wrap each wire individually with electrical tape to prevent short circuits. Finally, please use electrical tape to secure the black control box wiring to the LED emblem harness for a stable connection.

vw led bar plug 0215

Details photo about how to connect the led emblem to the led bar plug.VW LED EMBLEM PLUG 2024 12 03 14 14 24

Frequently Asked Questions: VW LED Emblem & LED Bar Connector

Q: Do I need to cut or splice my car’s original wiring?

A: No. Our kit is designed to be plug-and-play. All necessary connections are made between our LED emblem and the provided LED bar harness. You do not need to break, cut your vehicle’s factory wiring.

Q: How does the “T-Harness” connection work?

A: Installation is simple:

  1. Unplug the factory connector from your stock LED bar.

  2. Plug our harness into the factory lead.

  3. Plug the other end of our harness back into your LED bar.

  4. This “bridges” the power to your new emblem without damaging the car.

Q: Is there any manual wiring required?

A: Yes. While you do not cut your car’s wires, you will need to connect the wires from the LED emblem to the included LED bar plug yourself. This allows for a custom, clean fit.

Important Note: If you are uncomfortable performing this basic wire connection, we recommend professional installation or reviewing our installation guide before purchase.