There are several methods of installing the VW LED emblem. Today, we will discuss connecting it through the car’s fuse box.

Typically, the VW LED emblem has two wires: a black wire and a red wire. Connect the red wire to the positive (+) terminal and the black wire to the negative (-) terminal.

How to Easily take off the VW front emblem

 

Step 1: Find the Right Place to Connect the Red Wire

Locate the 10A Fuse: Start by finding a suitable voltage plug. Then, identify the 10A fuse in the fuse box. There are three 10A fuses, but we cannot specify which one is correct. You will need to test each one individually.

Testing the Fuses: Look for a fuse that receives power when the car is turned on and loses power when turned off. Remove that fuse.

Connect the Tap: Install the tap with the LED emblem onto the removed fuse, then reinsert the fuse back into the fuse box. This way, both the LED emblem and the fuse will receive power when the car is on or off.

There are pins at the end of our red wire. If you connect it to the tap, you can cut off our pin and use the wire to tap directly.

How to Connect the VW Led Emblem？

Like the following photos: The red wire is for the LED emblem (2017 ATS)

2022 01 04 16 30 15 600x800 1

Step 1: Find the Right Place to Connect the Black Wire

To connect the black wire for grounding:

Locate a Suitable Grounding Point: Look for a metal component or bolt in the vehicle that is securely attached to the chassis. Common grounding points include:

  • Existing ground bolts near the fuse box
  • Bolts on the vehicle’s frame or body

Prepare the Connection: Clean the area where you will connect to ensure good contact.

Attach the Black Wire: Use a ring terminal or similar connector to attach the black wire to the chosen grounding point. Make sure it is secure and tight.

Test the Connection: Once the black wire is connected, you can test the LED emblem to ensure it functions correctly.

Complete Guide Installing a VW Tiguan LED Emblem & Grille (No Programming)

This is an installation video on how to install the VW LED emblem and grille. You can check the timeline under the video to find specific installation sections.
The person in the video removed the whole grille to install the LED emblem, but if you are only installing the LED emblem, you do not need to remove the entire grille. Please ensure that you do not move the radar during installation. Also, confirm that there are no wires or anything else in front of the radar.

06:18 Tap into the fuse box for power

06:50 Connect the black wire to the grounding

Conclusion

We have shared the details on how to connect the VW LED emblem. If you still encounter any issues, please provide your order number and contact us for assistance.

Phone/Whatsapp: 1.281.425.5242